/ Technical Support ARM: OLD COMPILATION TOOLS IN MDK-ARM VERSION 4.13AInformation in this knowledgebase article applies to:. MDK-ARM V4.13aSYMPTOMDuring the update installation of MDK-ARM 4.13a, a message isdisplayed informing about already installed compilation tools with anewer version than those included in the MDK-ARM 4.13a package.What should I do? RESOLUTIONThe MDK-ARM 4.13a installer falsely reports this version conflict.The RealView Compilation Tools version 4.1.0.561 is included, whichis the latest version. We strongly recommend to overwrite theexisting files.If you skip overwriting the existing files by accident, the ARMLinker will report an error message when linking the code and nooutput file is generated. The error message could look like this:SELECTIONSCRIPT(1696): error: L6907E: Expected an expressionIn this case, please run the setup again and, if asked, answerwith 'Overwrite'.
SEE ALSO.Last Reviewed: Monday, August 20, 2012Did this article provide the answer you needed?
Mdk Arm Professional
If your ULINK have a bootloader is automatically updated if connected in KEIL MDK.But if not have bootloader you must do it manually.- on the ULink there is a NXP LPC2148. This device has a serial bootloader in ROM.- download & install Flash Magic from- to activate the bootloader in the LPC you must short 'P0.14/DCD1/EINT1/SDA1 (PIN 41)' to GROUND and power up.LOW on this pin while RESET is LOW forces on-chip boot loader to take over control of the part after reset.It may be has a two-pin jumper (J3) in the lower right under µC and USB Port.- at 'J2' is the serial update port available, from left to right: RxD in, TxD out, GND. Connect to PC RS232.don't forget use a level converter RS232 to 3.3V. Like as MAX3232- connect this port through a level shifter to RS232 Levels or a TTL-USB Converter to the PC- run the Flashmagic Software, select COM-Port, Controller and Target File and run the Update (sometimes the autobaudings hangs, cycle power and give him another try)Flash Magic ConfigSelect Device = LPC2148Com Port = COM xBaud Rate = 9600Interface = ISPOscillator (MHz) = 12Logged.